Hello all, I am now at my witts end so hopefully someone here can help.
I have a basic display that comprises an F16V4 a RP4 running FPP, 8 arches with 189 nodes in each, window frames and a small north pole with a light on the top.
I have mapped all my props, north pole on port one, window frames on port 2, 3 arches on port 3 and 5 arches on port 4. I have power injection where required and when I run the test sequences all props show Red, Green, Blue and white as they should however if I run a sequence (it doesn't matter which) the colours on three of the arches don't match the sequence.
Hopefully to you seasoned pros its a rookie error somewhere but I just can't get my head round why it would all be correct in test (in both the Falcon interface and the FPP one) but not in a sequence.
Thanks in advance.
I have a basic display that comprises an F16V4 a RP4 running FPP, 8 arches with 189 nodes in each, window frames and a small north pole with a light on the top.
I have mapped all my props, north pole on port one, window frames on port 2, 3 arches on port 3 and 5 arches on port 4. I have power injection where required and when I run the test sequences all props show Red, Green, Blue and white as they should however if I run a sequence (it doesn't matter which) the colours on three of the arches don't match the sequence.
Hopefully to you seasoned pros its a rookie error somewhere but I just can't get my head round why it would all be correct in test (in both the Falcon interface and the FPP one) but not in a sequence.
Thanks in advance.
