ECG-D2 with Renard

[dennyes]

I'm trying to run this board using e1.31 / dmx and converting it to the renard language and sending it out to SolisticeWerk's Teensylights16 board. I'm having trouble with the setup procedures and was wondering if you could give me any insight on how I should go about achieving this.


Also, do you have a PDF or documentation page anywhere explaining the ECG-D2? I have the P12R also and know basically how it works but for some reason I'm having trouble outputting the Renard protocol from this device and can't seem to find any documentation on it. Thanks!

 

[BrianJ]

To thew best of my knowledge the D2 is designed for e1.31 to DMX only. I think the bridge required for conversion to Renard protcol is the DR4. Check the Product Matrix

 

[dennyes]

DMX512, Renard Hyper DMX^


That's what it says under output for the D2

 

[dennyes]

I do see at the bottom that if using renard you are required to have a data link adapter. Anyone familiar with this adapter or any other method i could use to get this working?