ECG-P12S and ArtNet protocol

R

riri7707

Full time elf
Joined
May 9, 2010
Messages
222
Location
Paris / France
Hi,
Maybe I missed some info about the implementation of ArtNet protocol but I never arrived to configure it even if the option settings are available in the menu. I don"t find specific topic talking about...

I have of course the last firmware of P12S...

So I tried the basic IP as usual for most of the Artnet devices : 2.x.x.x (in my case 2.0.0.92), where my computer is on 2.0.0.90 with 250.0.0.0, but P12S was never been seen by any Artnet SW, even using DMXworkshop tool.

All my other artnet devices works great, but P12S stay in blind mode.

Any feedback will be appreciated here.

cheers...

Henri
 
I briefly tried setting up Artnet with Madrix and j1sys but figured I need to read up on Artnet first... Maybe if I have time a bit later I will retry... But I was glad to see Artnet bein g supported.
 
Yes,
Me too I was trying to use it with Madrix and other SW...
But seems P12S cannot support yet Artnet, or maybe I missed something...
A lot of try, but no way to make it working...

Other devices I have works perfectly...

Maybe there is a specific firmware to use or specific way do make it working,
but I have a real doubt here.

I will agree if someone sucessfull using Artnet with P12S
 
I also tried. Ended up using streaming ACN instead. Seems to work well enough for this year but might be an issue next year when I need unicast mode on all the interfaces.

The problem I was having was an inability to set which mode artnet- 2 or 10. I would hit save on the p12s and the value would still read as 0.
 
You must log in or register to reply here.
Back
Top