Verb75
Apprentice elf
Hi,
So I've been testing my lights and I've come across something new for me.
Last week I tested all my lights and started putting them up. After putting them all up I loaded up xLights and ran the all the lights from the "test" page. Everything lit up and I had hoped. I went in to have some dinner, left the lights on. After 2 hours, everything is looking good and normal. I reboot the controller and load a sequence. Sequence starts and everything is good for about a min or so, then all the lights on Port 2 freeze. In Xlights, everything is playing normally, so I figure its a simple glitch in the matrix. Reboot the controller and xlights. Issue happens again.
I've tried different sequences, same result. After a min or two...lights on port 2 just freeze.
I'm thinking I may have to reset my F4V3, but if anyone has another other ideas before I do that?
Thanks
Vic
So I've been testing my lights and I've come across something new for me.
Last week I tested all my lights and started putting them up. After putting them all up I loaded up xLights and ran the all the lights from the "test" page. Everything lit up and I had hoped. I went in to have some dinner, left the lights on. After 2 hours, everything is looking good and normal. I reboot the controller and load a sequence. Sequence starts and everything is good for about a min or so, then all the lights on Port 2 freeze. In Xlights, everything is playing normally, so I figure its a simple glitch in the matrix. Reboot the controller and xlights. Issue happens again.
I've tried different sequences, same result. After a min or two...lights on port 2 just freeze.
I'm thinking I may have to reset my F4V3, but if anyone has another other ideas before I do that?
Thanks
Vic