LED for the ACL Strobe

[MSL]

Hi all,

I have a few ACL strobe PCB's that I purchased in the coop a couple of years ago. I am now looking for the parts to build them.

I found these 8mm 0.75 watt LEDs on Aliexpress. Will they work (I don't know the voltage needed)?

http://www.aliexpress.com/item/Epistar-Chip24-40mil-8mm-Round-0-75W-Water-Clean-LED-Diodes-Warm-White-Cold-White-for/1204699685.html

If not, do you know where I can buy the correct one?

MSL

 

[AAH]

Those leds are spot on. You just need to make sure that when you load the boards you select the resistor for 0.75W leds as it was possible to load the board for 0.5, 0.75 and 1W if I remember rightly.

 

[MSL]

Thank you.

 

[Skunberg]

I think the info is in the wiki