cdjazman
Full time elf
- Joined
- Apr 24, 2012
- Messages
- 426
So I have my house setup as shown below with 2811 strips all connected to single pixlite 16 long range.
I have set the relevant starting location to be where the green dots are.
Side question - is the left as you look at the layout (house) ? Also when strip is vertical is top = left?
OK so I have setup a model group for the whole of the house. When i put curtain or garland over that model group it does not run smoothly from one side to the other. Some go left and some go right (as you look at it)
It looks fine in xlights....
I have tried different layout modes.
Also does the order of the models in the model group matter?
Any thought?
I have set the relevant starting location to be where the green dots are.
Side question - is the left as you look at the layout (house) ? Also when strip is vertical is top = left?
OK so I have setup a model group for the whole of the house. When i put curtain or garland over that model group it does not run smoothly from one side to the other. Some go left and some go right (as you look at it)
It looks fine in xlights....
I have tried different layout modes.
Also does the order of the models in the model group matter?
Any thought?