Hello all.
I have a HinkPix Pro controller with 16 outputs. My initial design is the following
Mega Tree - 8 ports - 100 lights per port
Arches - 2 ports - 100 lights (50 per arch) on the right - 1 port and the same on the left side
Mini trees - 2 ports - 100 lights (50 per tree) on the right - 1 port and the same on the left side
My controller will be on the mega tree - I would like to run the least amount of lead wire as possible so I would like to run the wire from tree to the first arch and first tree on either side., BUT make it read from left to right. Any and all help configuring is appreciated.
As of now, I have a strand of 100 pixels and it is plugged in to port 9. The first 50 pixels are reading something from the mega tree and the last 50 are reading the far left arch. Any idea what is going on?
I have a HinkPix Pro controller with 16 outputs. My initial design is the following
Mega Tree - 8 ports - 100 lights per port
Arches - 2 ports - 100 lights (50 per arch) on the right - 1 port and the same on the left side
Mini trees - 2 ports - 100 lights (50 per tree) on the right - 1 port and the same on the left side
My controller will be on the mega tree - I would like to run the least amount of lead wire as possible so I would like to run the wire from tree to the first arch and first tree on either side., BUT make it read from left to right. Any and all help configuring is appreciated.
As of now, I have a strand of 100 pixels and it is plugged in to port 9. The first 50 pixels are reading something from the mega tree and the last 50 are reading the far left arch. Any idea what is going on?
