Facebook
youtube
Home
What's new
New posts
New display videos
New media
New media comments
Latest activity
Forums
New posts
Search forums
Wiki
Search wiki pages
Media
New media
New comments
Search media
Display videos
New display videos
Search display videos
Display locations
Displays by region
Members
Current visitors
Latest activity
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Navigation
Install the app
Install
More options
Close Menu
New to Christmas lighting?
Get started with the
AusChristmasLighting 101 Manual
Home
Forums
Welcome
101 display basics
wiring for power injection advice.
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
[QUOTE="Bartjet, post: 110336, member: 32623"] Hello everyone, I am just getting into this hobby and am starting with rgb on my house. Following a design from a YouTube video, the plan is to put strip inside alluminum channels on the ridge lines of the house. Where I am running into trouble is with power injection wire. I am trying to make it clean and not have wires showing everywhere so I was going to run the power injection wires inside the channel with the led strip. But in following a guide I saw on here about power injection and using 14AWG wire, the outdoor 14/2 cable doesn't fit in the channel. So my curiosity is i have a lot of 14 guage THWN cable that will fit with the led strip in the alluminum channel, it is rated for wet conditions, but i am not sure if I can use this method legally and safely. Any advice would be greatly appreciated. [/QUOTE]
Verification
The title of our introductory lighting manual contains a three digit number. What is that number? Clue: Display basics forum
Post reply
Home
Forums
Welcome
101 display basics
wiring for power injection advice.
Top