I think I just worked it out. I was accessing the GUI via the eth0 IP address before. I just accessed the GUI via the wlan0 IP and now everything seems to work fine. I can also access the GUI from my mobile via the wlan0 IP address too!!
Also, the list of songs does not appear until I click on the playlist drop down menu. Once I click this, I can see the songs, but still nothing about it playing.
The device is connected via WiFi and that is how I access the GUI.
I tried to manually set the date/time and when I press submit, the fields just go blank.
I shut down system via mains power and let sit for 30min, rebooted and get same issue. If I reboot FPPD via the GUI, same issue exists also.
Hi There Team,
I have booted up my lights to start testing before setting up for 2021. I started my RPi (Stand Alone Showplayer) that is running a BBB for a Matrix and also an F16v3 for a mega tree. When I reboot FPPD, the sequence starts playing, but no info is on the status screen, so I cannot...
Hi All,
I am trying to test my set up, I can output to lights in xLights and get everything to work, but when I run the show from FPP (Pi 3+) it does not work. I get sound from the Pi, but nothing to my F16 v3. When I go to channel outputs in FPP, I select 2 outputs as I also have a BBB Matrix...
Hi Alan,
Thanks for your feedback, I think my problem was the subnet mask as you pointed out. I ended up formatting my SD card, reimaged and set up with new IP addresses and all works perfectly now. Thanks
Hello, I had to change our Telstra model yesterday and subsequently the WiFi settings and the router IP addresses are different.
Now for the life of me, I cannot connect to my FPP Pi3 to change the WiFi settings and gateway IP address. I have my Pi powered up, connected via LAN cable to my...
I was trying to create a new controller in xLights for the DMX card which was not working. What I did was put the DMX props on the last universe of the F16, start channel 1, then set up the serial output 2 to start on that universe channel 1. Just make sure the pin outs of DMX port 2 are the...
How would one set up the controller in xlights? I assume I would use an ethernet controller as its connected to serial port 2 on F16, and multicast as I cannot set an IP of the DMX board. Do i set it up as 1 universe of 512 channels, or 1 universe of 36 channels?
Any help would be appreciated...