Recent content by MSL

352 DMX channels, 16 foot Mega tree, Mini Trees, Arches, Bulls eyes, Ground lights, Poles with Stars and several Blow molds.

352 DMX channels, 16 foot Mega tree, Mini Trees, Arches, Bulls eyes, Ground lights, Poles with Stars and several Blow molds.

352 DMX channels, 16 foot Mega tree, Mini Trees, Arches, Bulls eyes, Ground lights, Poles with Stars and several Blow molds.

352 DMX channels, 16 foot Mega tree, Mini Trees, Arches, Bulls eyes, Ground lights, Poles with Stars and several Blow molds.

352 DMX channels, 16 foot Mega tree, Mini Trees, Arches, Bulls eyes, Ground lights, Poles with Stars and several Blow molds..

Thank you.

Hi all, I have a few ACL strobe PCB's that I purchased in the coop a couple of years ago. I am now looking for the parts to build them. I found these 8mm 0.75 watt LEDs on Aliexpress. Will they work (I don't know the voltage needed)...

Thanks for responding... I checked (the best I could) all the pads. They all seem to have been soldered. I did learn (after pulling a few hairs out) to twist the insert in the board to make contact. I did solder these with a heat gun on an 3/16 inch aluminum plate. Some of them I did get...

Hi All, I need so help on some strobes that I cannot get to work correctly. I built 90 strobes. After I built the strobes I programmed each one. I had a few that did not program and I found bridges that I fixed. 2 of the 90 I could not get to work. I soldered the (three) wires (5v, ground...

Thanks for the replies, One less thing I have to worry about. Mark

I am starting to build the strobes from the last coop and I have a question... Is the P2N2222AG supposed to sit up from the PCB (about 2mm)? Some sit up; some go all the way down and lay flat on the PCB. How are they supposed to be installed (or does it matter)? Mark

PM sent about strobe light covers and paste. Mark

Payment sent. Thanks again, MSL

Thanks to all who responded. I think I will be using the relay as it seems to be the simplest. Any ideas on a power supply for the strobes? Mark

Hi All, I got into the ACL Strobe Light Group Buy. The strobes use 5vdc. I am using LOR and Lynx Express equipment that puts out 120 volts (ac) (I am in the US). I looked out on the Wiki for controllers that put out 5vdc. The only 5vdc controller listed is LOR's CMB-16D. Is that the only...