Notenoughlights
Latest activity Postings Media Albums Display videos About
-
-
Notenoughlights replied to the thread 12v Portable Setup.A few things to add: - By RGBWW I assume you mean RGBCCT (warm+cool white) https://www.aliexpress.com/item/1005006420002446.html? -... -
Notenoughlights replied to the thread Falcon F16v5 wiring schema for high-current 12V WS2815 installation — sanity check requested.Just looking through your power calculations here 7,168 leds running full white, I've gone and used the Quinled power sheets to find...
-
Notenoughlights replied to the thread Budget Layout Help.I would dress up those big rocks around the front with a big matrix.
-
Notenoughlights replied to the thread Need help designing layout for a new install — thoughts?.Take my approach. Go out at night and if it's dark put lights there. When you have installed lights, go out again when it's dark, and if...
-
Notenoughlights replied to the thread What are your Standout Props?.I acquired these for free, didn't build them sorry so no writeup :( They're basically acrylic tubes custom made with 2 air ports low...
-
Notenoughlights replied to the thread What are your Standout Props?.The bubbles were very very popular for the 2025 Christmas season. My lawns and roof always also seem to get a lot of attention, I don't...
-
Notenoughlights replied to the thread Wanting to make a 16x50 mega tree.High density seeds = hard to repair, perhaps consider alternate node 50mm spacing strings if you want 25mm "spacing" between them. Strip...
-
Notenoughlights replied to the thread Pebble seed colour issue.I believe the Pixlite 16 can only do one pixel type across all outputs.
-
Notenoughlights replied to the thread Pebble seed colour issue.Absolutely, you'll need to tell xlights they're 4 channel lights though, same for you controller.
-
Notenoughlights replied to the thread Pebble seed colour issue.They are usable, I prefer them over RGB as they use less power if you're wanting to use white in your display, as they've got a...
-
Notenoughlights replied to the thread Cable End Termination - What do you use?.I mean it's fine for 5-24v but anything more I would be using something more robust, I would not for example be doing that for anything...
-
Notenoughlights replied to the thread Cable End Termination - What do you use?.If I don't plan to connect anything to the end of a prop, i'll crop the wires and put on a bit of glued heat-shrink tubing, heat that up...
-
-
Loading…
-
Loading…
-
Loading…
-
Loading…
-
Loading…