-
-
DSo Sept of 2024 I started down the road making yet another parade float. This time a cartoon Locomotive. 10 months later... View...
-
Ddannyp replied to the thread Power supply for Baldrick 17.Not really having any experience other than my existing meanwells, do you have any recommendations on the type I should be searching...
-
DThe Baldrick 17 has 4 X 30 amps plus 1 10 amp input. I am using 12 volt seeds 540 seeds per output at 30% brightness. I’m just...
-
Ddannyp replied to the thread Baldrick 8 wont update.Thanks to the team at the zoom room, this has been fixed. It was a problem with my network set up.
-
Ddannyp replied to the thread Baldrick 8 wont update.Thanks Dom. Will try that
-
Ddannyp replied to the thread Baldrick 8 wont update.No there is nothing unique. I will check the network later this week when work allows me. Can I just plug the board into the router...
-
Ddannyp replied to the thread Baldrick 8 wont update.Telstra. The biggest in Australia
-
Ddannyp replied to the thread Installing Coro Props.For the railings, cable ties are your friend.
-
Ddannyp replied to the thread Installing Coro Props.Depending on your desire to screw into the corrugated iron, you could get some tek screws in the same colour as the iron and just screw...
-
Ddannyp replied to the thread Baldrick 8 wont update.That’s through the switch. It must be something with my setup as I plugged in another board and got a different ip address but it still...
-
DHi I have a Baldrick 8 and am trying to set it up. I have connected to it and it has an IP address, but when it starts the software...
-
-
Ddannyp replied to the thread How to connect seeds to controller.It’s a baldrick 8 but never used yet
-
Ddannyp replied to the thread How to connect seeds to controller.actually I have a baldrick board. Would that be able to be used with more than 400 seeds per port?
-
Ddannyp replied to the thread How to connect seeds to controller.So 8n your experience 400 seeds is fine? I would prefer not to power inject either if I can get away with it? With a falcon f16 that...
-
Ddannyp replied to the thread How to connect seeds to controller.I got my seeds from light it up leds but they are closed down now.. I don’t really understand the swapping around of primary and backup...
-
-
Loading…
-
Loading…
