Recent content by dannyp

That’s a great display Kent. Well done on getting it up

Using the latest version that downloaded today. I will try and use an older version and send what happens.

Correction the problem was not fixed. I repaired the files as suggested and then went back into Xlights and started working on a sequence and assumed everything was fixed, but I forgot to use the test function. I needed to test something tonight but still getting the same problem. I’m not sure...

Yes this fixed the problem. Many thanks

Got it. Very helpful. Thank you

Normally it’s from the v2 which powers the right hand side of the pixels. So just run a wire from the positive of V2 to the positive of the EXT. What about the negative? Removing the switch also sounds good as I always powered it from the v2 power but will try the first option as I’m not sure...

Hi does anyone in Australia repair falcon controllers? I accidentally hit my controller and now the switch that indicates if power to the cpu brain isn’t connected properly and it either switches on or off depending on movement. When I hold it down so that the falcon powers up, it now shows a...

Is this in a directory on my Pc or something I need to download?

For some reason my Xlights keeps becoming unresponsive when I hit the Test option and then just goes into a loop and I need to kill the application. I have updated to the latest version and same problem. I dont have any other ideas other than I'm thinking of deleting Xlights but am concerned...

Thanks for the suggestion. It turned out that I had the wrong vales in the strings and nodes section. When I updated, its all works now. many thanks.

I have a p5 panel that is 4 wide X 5 high and I have been able to get it going, BUT the screen is duplicated with the image appearing on the 2 panels on left hand side of the panel and then again on the 2 panels on the right hand side. It is as if it is outputting to two 2x5 panels side by side...

Not really having any experience other than my existing meanwells, do you have any recommendations on the type I should be searching for? I did a search and I’m not really sure what I’m looking for, or the size of the unit for the bald Rick?

The Baldrick 17 has 4 X 30 amps plus 1 10 amp input. I am using 12 volt seeds 540 seeds per output at 30% brightness. I’m just wondering how best to power it up. The power supply will be under cover externally. Some questions/thoughts Should I get a a big power supply or multiple small...

Thanks to the team at the zoom room, this has been fixed. It was a problem with my network set up.

Thanks Dom. Will try that