-
-
Juddge replied to the thread 2025 Board Update.Try the Hanson HE123 with expansion or TX/RX Remote Expansion - still FPP but wont be limited to 8 ports per board its a BBB fpp Board... -
Juddge replied to the thread Best material for Arches.in australia it is called " Air Seeder Piping Translucent" it is normally purchased from Farming Suppliers, i have 32mm OD Version, i...
-
-
Juddge replied to the thread Answered How to run sequence and get the outputs running.OUCH - last time i did that, i saw every pixel POP
-
Juddge replied to the thread Next steps after creating sequence.render the sequence - Save the sequence - Goto the controller tab - Visualise all the models to the ports they are connected to, then...
-
Juddge replied to the thread Power Supply - JT-DC36V6W-E1-IP44.not the same, but its for 2 wire, DC Lights , as i dont need it as i use DC2-24 to power it im in penrith if you would like the power pack
-
Juddge replied to the thread Power Supply - JT-DC36V6W-E1-IP44.i have a 34V version, should be the same, 8 modes
-
Juddge replied to the thread Power Supply - JT-DC36V6W-E1-IP44.ill check when i get home possibility i have one
-
Juddge replied to the thread I'm a convert..Right now it’s 100% Hanson electronics , but the baldricks definitely have a place in my lineup
-
Juddge replied to the thread I'm a convert..I can see my entire show being Hanson electrocnics and Baldrick equipped
-
The safest way potentially is to open the sequence on the source machine. Go to tools> package sequence. This will create either a .zip...
-
Has anyone used one yet ? i really want to see how they work, because if it does work, it would be intersting to see the data from our...
-
Juddge replied to the thread Can not get HE123RX to work.did you get this working ?
-
Juddge replied to the thread Can not get HE123RX to work.if you only have 1 expansion it automatically sets the expansion as ports 17-32 so you may have to move the expansion to the right side
-
Juddge replied to the thread Can not get HE123RX to work.also the left side is ports 33-48 , where as the right side is ports 17-32 have you got them set right in xlights controller setup ?
-
Juddge replied to the thread Can not get HE123RX to work.is your main controller set to have the expansions in xlights controller page ? have you used visualiser to add the props to the ports...
-
-
Loading…
-
Loading…
