Recent content by bhamze

100 clips weigh approximately 1.5 lbs. Box dimensions are roughly 10.5" x 2.5" x 5".

I wouldn't mind but I have a few concerns. First, I need to determine if the clips fit the PVC available in your country. Second, I would image shipping cost would be high. Can you confirm PVC diameter, the clips were designed to fit 1/2 PVC (.840").

For those following the development of the 1/2" PVC pixel clip "KlickPx", they are now available for purchase at rgbetc.com. Below is brief video description. Thank you. https://youtu.be/FlhcSIrgDTs

Same here. I've tried to contact Ed several times with no response. His site also has not been updated since the change. Curious if things are OK and if hes still in the business.

They fit round or square nodes via an insert. Check link below. https://youtu.be/JFz8G4iGne8

Im working on a new site and it will be up soon. Clips have been tested and approved for production. I will post updates on my FB page, link below. Thanks for your support! Bill https://m.facebook.com/RGBetc

My jumpers (top board) are correct, I successfully ran show last year. I was curious about the jumpers on bottom board, currently none are installed. My controllers are configured differential and all channels communicate with PPR-B's. My issue is with v3_4B, my controllers (2) have no response...

Robert, Can you please share your findings? Picture's of jumper configuration would be helpful. Im struggling with v3.4b. Any help is appreciated. Thanks.

Thanks Ben!

Uploaded v3_4B on two separate P12D controllers. All channels, on both controllers are configured to differential and wired to PPR-B receivers. Both controllers did not operate lights after the firmware upgrade. I tried reinstalling firmware (Master and ASIC 1+2) but results were the same...

Thank you!! Is it safe to assume the update will work on the P12-D?

I noticed these new toys while searching Eds site. Does anyone have any information on these devices? I reached out to Ed, no response. I have three display elements, each containing 54 pixels, the distance between elements is roughly 25-30 feet. Because of the distance I will need several nulls...

Its been several months, any news? Any chance on scoring a beta release? I really need this for my July show! Any help is appreciated, thanks.

Thanks for your interest. I've selected a tooling/plastic manufacturer and tooling will be launched soon. I plan on sending an update sometime next week.

Thank you! Patiently waiting :)