Recent content by bngoofy

Thanks for testing. I also got the same result. Hoping there is a fix or that I missed something that someone may see

Hey All I'm testing my first Mega Tree and seam to be having some issues. Tree is 44 Ports with 100 Node Per String (Mattos Evo Pixels) (300 Channels Per String) and a 3 String 270 Node 5 Point Star. using ports 45 - 47 I have 3 LOR Pixie 16 and set up a controller on a clean instance of...

Never got this to work. I am now just trying it with a simple RGB Flood. The Enttec communicates fine using a software console but with a clean instance of xLights I can't seam to get it communicate. Any Help would be appreciated

Mike I got a new 5 PIN DMX cable directly from the Enttec to the SM and using your suggested settings. Still not working. Any Ideas?

I checked the LOR Adapters and found that the LOR adapters are 3 pin XLR and pins 2 and 3 are reversed. Not sure thats the issue but I ordered a 5 pin cable to eliminate the variable and it will arrive tomorrow for testing.

Thank You! I did try this and no dice. I set the SM to 1 and Speed to 250000, as you suggested, rendered, connected and same result. Did not run. I also changed the prop port from 10 to 1 and it did not run. The device ID is 10 and Enttec has only one output. One more thought, the adapters...

Look at Mattosdesigns.com for hardware and they sell pixels that are very low power consumption and bright. just 8ma per node. i set up a 6400 pixel tree this year with 4 LOR Pixie 16. Basic patterns are all in xLights

I have three ADJ Entour Snow machines (SM) that I was forced to trip manually this season. I am attempting to get an Enttec OpenDMX to trigger the snow. The SM uses 5 Channels with channel 3 being on-off at values 128-255 for on and 0-127 for off as per the ADJ Manual. I set the DMX address to...

Newbee in Florida. Looking for some after season advice.