Recent content by Bumpy2020

These like a good replacement for my strip on round conduit, but printing 20mtrs+ of the seed mounting in 300mm lengths might take awhile :| Well done on the 3d designs :)

Very good write up Do you have more details on the garage door matrix ? Id like to try and build something similar

I have spent along time troubleshooting issues, dead pixels and a controller which looks to be dying

Think I might of found the issue If I turn on supports, then it looks like it will print the missing bit This makes sense, as it has to slip inside the hub, so would be raised

I tried printing the 105% files, and the bit which goes inside the hub didnt print properly In cura I notice it doesnt try printing it until layer 19, by which time the nozzle is too high ? The pic is before it started printing the missing bit in thin air View...

Use the cable tie mounts, but put silicon under them

Now that is a work of art :)

That is the one I'm looking at, but in 4mm

I have some hikvision ones connected to my Synology, thinking of adding an 8mp (4k) one next

More details on the lights ?

I want these

I have the 2nd strips, and they never turn on unless the data is telling them to

So I changed out the cable taking the data to the string, seams ok now :/

So after lots of playing, it appears the string on output 1 is causing the others to go flakey With output1 unpluged, the other 2 seam to work ok

So unpluging all PI cables and all outputs apart from 1 string powered off pixlite Test mode on pixlite works, everything flashes red/green/blue/white But with lighting part of the string, random pixels flash fast