Thank you. My P2 and power supply will be within 8 feet of the first pixel on my matrix. I was hoping to run 4 strips per output of my P2. Cutting the strips into thirds so I would have around 5' by 24 pixels high give or take when it comes time to put it together.
I will see if I can switch...
I did not have a ground from controller to strip. I had ground going to the power supply.
Thank you for the information on the groups of 3 for the 12v strips. I guess Ill see if I can change my order to 5v strips.
If I moved to 5v, I would probably need to infect power at the start and end...
Hello,
Ive been watching videos and reading on how to test some strip pieces just to get comfortable. Soon as I power up the board and strip, the strip piece just starts blinking different colors, even if I dont have a program open. Just wondering if Im doing something wrong. I have the dat...
Thank you all. I believe this will solve my problem. I was putting 10.10.10.10 into my pc and 255.0.0.0 in the mask. I will hook it up to my cameras usb cable tomorrow and try this out.
Do I need to add any other jumpers to my board besides the jumpers I placed on K3 pins 1-4 ? Those are the...
My P2 did not come with a USB. Only came with the board. I havent tried using my ip and increasing by 1. I will try that tomorrow. I have D/C my stuff for the night. Thank you for the reply.
Hello,
I have a P2 controller that Im trying to play around with. I have Jumpers on k3 pins 1,2,3,4 for 12v. I followed a video I seen in one post on configuring the ip as 10.10.10.10 and the gateway as 255.0.0.0. I completed that but can not access 10.10.10.10. Just says page unavailable...