Recent content by DinoChickenSuit

Buuutttt.... if I made a new account with the same card, I would get the deal, right?

Urrgh... AliExpress strikes again

Thank you!

Great!

Not doubting what you're saying, but the supplier says its 'Shenzhen Rita Lighting Technologies' https://www.aliexpress.com/store/312912?spm=a2g0o.detail.0.0.20ceniTvniTvcw

Oh, you think they would be good? I'm just always paranoid about buying things off of AliExpress

Hi all, I am running a small show this year (~500-1k px), 5v, but i have a large area to cover (~40m frontage). I am running a 5v Baldrick 8, but im extremely budget conscious. I just saw an AliExpress sale on xConnect pigtails, and I was thinking, are they legit...

Ah, nice. I should have gone that route (our front fence is ~40m), but I started off with Arduino lighting, so all my LEDs are 5v... 😔

Hey! I printed these a few months ago, but didn't get around to putting them up. Are you using 5v or 12v for them?

Ah.... I'm using the inbuilt WLAN0 on the pi, could that be the problem?

Hehehe ‘ZuckerBook’ I’m stealing that one

The snowflake can be found here: https://www.thingiverse.com/thing:4092353 It took a few hours per arm, not sure on the exact numbers. Each prong is 22.5cm.

Hey Jeremiah. I am pretty new here, but i have printed a snowflake for this year. The thing I found is, it uses too much filament to be economically viable. Coro will be cheaper in the long run.

Sorry, haven’t been on in a few days. No, I’ve tried it on a wooden desk, a wooden floor, and in a 3d printed case. No luck Could you elaborate on this? That might be the problem

The newest version of FPP and xLights This is the first I’m set it up, so it shouldn’t have an IP problem, right?