Recent content by fugley

the next one then is the one that scares a lot of people (AI-Powered Video Analytics) there are some free ones around although I'm not sure how well they work

you could do this with something like a beam break sensors which you'd hook up to home assistant and record stats I've not seen one for years ( you may have seen one on a shop door entry )

Sure! Here's a cleaned-up version of your text: Sometimes, it can turn into a real mess! :( Normally, we have two busloads a night from the local community trust, who run a heritage bus tour of the Christmas lights each year. However, I didn’t know until recently that the neighboring town...

Dam!!! you have me thinking lol as light failure and the replacement of what would really need to be whole strips to make it quicker and easier is the overwhelming concern

I had an interesting conversation with my local Community Trust after they left a note in my mailbox asking for help. As soon as the call was explained, my gut feeling told me this might not be the best path to go down. They want to replace the old, aging, Christmas tree in the main street...

like a lot of us trying to video the show id been hunting around for just the right setting and after putting the DSLR camera to one side i thought id go the quick dirty way and grab the phone to try this this was ten times faster and easier with amazing results than playing with the ISO and...

heaps on here https://xlights.info/

yeah was kind of hoping there was an easy quick trick I've edited the file in the passed only saving the version I wanted and repeated as needed although like you'll know it takes a lot of editing and time

Not really a big deal as I've been using autolyrics for sometime now without a problem although I was wondering about upping my game a little 🤣 is it possible to spilt a main voice and backing voice with this and is so how one thought was to only give it text for each role at a time ?

id STRONGLY advice that because what happen to me was the longer loops hocked around each other in the wind and ended up pulling the wiring out the back of the pixels

made a similar frame for some props and just put tube back on an angle using delta inspection tees so the props were just off vertical and fall back a little and then added sand bags to hold it down where i needed the delta tees to go four ways i replace the inspection lid with a 3D printed...

the other draw back i have atm would be "fire" the CNC I built years ago has a vacuum table with a mdf waste board

Cheers nice info ... at the risk of a courier breaking a co2 tube still wondering about trying an air assisted module o_O I cut my holes at 11.4mm 🤣

what size laser - watts what speed - mm/minute how many pass - if more than wondered about putting a laser on the CNC although id always been looking at a c02 tube laser and was nerves about it breaking on shipping

clean the tip of the soldering iron best thing i did when using seeds at that spacing was to just waste one or two seeds don't cut in the middle, cut hard up to the next seed and throw it away so you can get as much wire as possible