Recent content by Gerald

I also notice that when playing a sequence the master player shows on the multi sync page that it is playing but the projector pi is idle, however if i change this to uni cast and disable multi cast it does play but the picture is terrible. I do have another pi 3b+ however that does show playing...

My setup is a stand alone pi 4 as a master player and another pi 4 which is in remote mode for the projector. I do FPP connect with fseq sequences to both pi,s

They are the same as last year 108 x 192 , 1 strand and top left start

Hi I am having some problems with my display this year as I have upgraded several controllers and one FPP running a vrtual matrix, which does not diplay sequences correctly. I have attatched some screenshots of my settings for info Also what are the correct x lights settings for these...

Hi Merry As usual you came up trumps for me, after a few more hours and this time using xlights individual output to lights node making sure that the correct physical node was in the correct hole when re wiring the prop , I think that it is now wired correctly. I have done sub model tests of...

Thanks for your help here , I will look at all these things tomorrow.

Here are some photo,s and a video and also a link to a video View: https://drive.google.com/file/d/1F0jr9nG055Cm0ywjTA9au__Rv5vsRgms/view?usp=sharing

Unfortunately my prop does not have a printed path so I am to some extent working blind When powered up all of the rings are lit fine but when I try the spokes as it were there are two or three out of line , I have checked these in X lights and they do light up as they are supposed to I.e. no 34...

My prop does not have the path printed as it was sourced from the UK, however I did download this pic and have followed it together with the xlights diagram I have it on a Baldric controller on one port with power balancing and it is set to the channel start from xlights upload to controller as...

Hi I am trying to populate the 541 SS spinner but having display problems with the sub models, I have wired if from pixel 1 center anti clockwise as shown in the wiring diagram from x lights All of the individual rings light up correctly when testing output to lights from within x lights ...

Thanks for the confirmation, I am always grateful for advice from the experts on here

How do you power inject 4 wire pixels , do you just cut the red positive wire from the first supply and leave the negative to join the new one or do you also have to cut the negative from the first supply also? I assume you leave it to provide the joint return path for the data which was joined...

Thank you Skymaster, It was the wiring on the DMX plug at fault (I need to get my specs changed) I have corrected this now and I can output test from the Falcon and from a sequence in xlights However at present I cannot get a sequence to play from FPP , but this could be down to the uploads...

Hi All I am trying to set up 2 DMX floods in xlights but having no luck getting them to work, I have made a ethernet to dmx lead using the pin outs and colors shown in the manual and have configured the floods to channels d001 and d008 on there settings. These are sequenced into xlights and...

Adding a projector to an existing setup with the pi already added with a Hanson rp28+ , how do I add the virtual projector setup? Do I add this in fpp and then draw the matrix in xlights, if so will this add the correct path in the visualiser I have looked at the videos on line but all seems to...