Afternoon,
I have a prop which I'd like to add some power injection to, with the injection coming from a 2nd power supply. I have connected a male and female pigtail together with only the data and negative points connected. I place this custom pigtail connector between the last prop into a T...
Hey Team,
Hope you're well!
Is their a way to edit imported lyrics? I up loaded the lyrics to a song and spent some adjusting the timings, only to find an error with the lyrics. Is there a way to edit a specific block of lyrics?
Cheers
James
Thanks @darylc
I've managed to set up a VM in Xschedule with a size of width 192 x 108, but when I play the sequence via Xschedulr only top 1/10 of the butterfly effect is showing. I've attached a screen shot of Xschedule, the xlights set up and the VM matrix
@darylc sorry for further clarification I already have one data projector setup in Xschedule. The video file is loaded along with the sequence. The bit I need assistance with is setting a second projector which will share the same sequence but run a different video. If this need to a be a...
Afternoon all,
I have an existing projector connected to my show. I'm looking to add second projector but want to run a separate video to the one first? Both videos will be synced to the same audio and I'm hoping to run both videos at once. I'm running my show from X scheduler on a windows PC-...
Thanks @Iain I actually found the Video Hardware Decoding on xlights under preference/other tab and switched it on. Then rendered the clip again and all is working perfectly. Appreciate the reply!
@keithsw1111 thank you for getting back to me.
I couldn't find Video Hardware Decoding (is this in Xlights or Xschedule?) I did find #Use Hardware Accelerated video on Xschedule. I've turned this off and the video plays on my monitor (1920x1080) no problems, but when I move to my data projector...
Evening,
I'm getting flickering on my video when using the FSEQ+video on Xscheduler. The video type I'm using is an MP4 frame width 1280 height 720. The monitor size is 1920x1080
Just wondering what I need to do to correct this?
Kind regards
James
Morning, thanks for the advice!
My entire display is 5V already, so to change just the tree to 12V, would be a pain to be honest. Unless I can be convinced other wise :)
HNY!
Well this was my first official Christmas with the use of pixels on the outside of my house. I'd had great success for a number of years with pixels on the inside of my house (apartment living). My mega tree caused me untold grief, especially with the Sydney thunderstorms just prior to...