Recent content by M5Trader

I got on XLIGHTS Zoom Call and got it taken care of. I highly recommend it. They were very helpful.

Hello all. I have a HinkPix Pro controller with 16 outputs. My initial design is the following Mega Tree - 8 ports - 100 lights per port Arches - 2 ports - 100 lights (50 per arch) on the right - 1 port and the same on the left side Mini trees - 2 ports - 100 lights (50 per tree) on the right...

I changed the Nodes/String to 100 and saved and rendered it. And changed the # of strings to 8 since my total strings was 16 x 50 nodes.

Well Looks like I stumbled on the solution. It was both some settings in Xlights as well as the controller configs.

I have it set up as a tree model. From all indications, I have it set up correctly in Xlights. but something is not translating to the controller and then to the lights.

Did all that but I think there is something else going on. I am in the US on east coast so I am headed to bed. Will look some more and post. Again....Thank you all for your comments.

Ok so I am doing a test with only 6 ports for now since I can not do the full 8 since I have to strands being replaced. I would think doing 6 ports for a total 6 strings of (2) 50 pixel sets.

When I do that it give me 32 strands so I think I need o leave the # of Strings at 16. Still not doing it correcting from the controller.

Hello all - First year doing Christmas lights. Been wanting to do it for some time and decided to do it this year. I am doing a Mega tree from Holiday Coro, 4 mini trees and 4 arches. I know the ideal setup is to do a 16 strand megatree with the 16 ports. I was hoping to do the tree on 6 ports -...