Recent content by moogle

I'm using two 300W Meanwell's and probably going to restrict the LED outputs to about 80% in the advatek assistant client. I'm more worried about the power injection leads are not a suitable size.

So I've had a look on Ray wu's website the cable is 0.75mm2. This is an image of the stage layout. There are 40 pieces of led strip all at 1m each in length. The led's are split into 4 runs of leds at 10m each. Each of these 4 led runs have power injection every 2m of LED strip. So a total of 24...

Hi all, I'm currently building a setup using 40 meters of ws2812b 5v pixel strip which has 60leds/m they draw roughly 14w/m. Now I've built a rack mount that houses two 60A power supplies plus network switch and pixlite controller. This is going to me mounted under a stage desk and the plan is...

Hey everyone, just wanting some confirmation on my ecg-p2 programming. I have made a pixel display 1.2mx1.2m it is 14x14 ws2801 modules. Im splitting them in universes of 7x14. They are wired in snake from bottom left /up down. So on my string config, i activate first two universes. Split...

Im using ws2801 modules 20pcs per string from ray wu. Using the new p2 so injecting power with 2 x 250w power supplies. The 1.5mm v90 cable i used is rated to 19 amps up to 5metres. So all is good there. Would a 10a fuse be too big dont want led strings to be damaged if Anything happens :/

Hi there, Just want some confirmation ive worked this out right. Im making an Led matrix. 49 modules per panel. And a total of 8 panels altogether Power supplies have three outfeed wires. So im going to hook up 65ish Leds to each 12v output lead. They are .96w a module. Do i do .96x66 And...

Thanks for the help. I forgot.about the diagram in the manual :-[ I might just get the j1sys and be done with it as this will be able to program my full size array when its complete And i dont need any interfaces with the e1.3. No point in buying the dmx interface then switching. Was going to...

Hi everyone, I purchased a bunch of ws2801 strings from ray along with.a dd-100 mini dmx decoder. I was wondering about the wiring of the input. Can anyone point me in the right direction. Do i need a usb to dmx interface and then wire up a dmx plug to the decoder. Or can i wire it up directly...

ahh thats good to hear. I assumed so, however the wording on the madrix website was making me think i needed an approved controller. I will definitely be buying a ECG-p2 as soon as they are released for my 900 pixel array im making soon. I thought i was going to need a more expensive 8...

Im not sure if this is an easy question to answer but, will the new p2 be Compatible with madrix. Either the e1.3 or artNET? Or do you have to use Pre approved controllers? Thanks in advance :)

just a quick hi, found the site after something extensive googling looking for information on ws2801 configuration and software. Got to say this site is full of useful information and am very glad i found it! Im going to be building a large matrix array of 900 pixels and will be writing a...