Recent content by RonyRooman

One other thing I tried was to remove all props on my setup in xlights before the bad one. So remove all props on port 1-6 and let my prop on 7A be the first of any. Still get the issue with this test. Scratching my head for sure.

Thanks for the input. I've thought about this too but I can't find a smoking gun. I have one situation where I have a "roof top" prop with 127 pixels physically but the last one isn't in use so I set the total number to 126 in xlights. Thought this might be a problem so switched it to 127 and...

Thank you for all your help! I will try to swap out the pigtail on this port. However, I'm skeptical this is the issue since it works correctly when I hit the test button on the SR. I thought maybe swap out the network cable but everything else is working including B and C as this is on A...

If I do other tests on my F48 (color wash, red/green ramp) I get a lot of flickering of the lights.

Switches on my differential receiver look right. I reset my F48 and re-uploaded my config and the same issue persists.

Here's my F48 config. It's the prop on 7A having the issue. 7B is empty. 7C works fine.

The check sequence shows no channel overlaps but does show model groups having overlapping nodes. I attached a screenshot of that but I don't think that's an issue. "Lower Window Left" is the prop having issues.

When you say "Double check the receiver selector dial vs what you told xLights". Are you referring to the settings on the differential receivers that specify it as A, B, or C? I'm using an older version of the differential receivers (v1 I think) which has the switches for this. I'm pretty...

Here's a screenshot of my visualizer. I'll look to get one of the F48 web page. It's the "Lower Windows" on port 7A that is having the issue.

The pixel lights I'm using are all the exact same and should be rgb. I've used this prop for the last 4 years without issue. I tried updating the color order (to grb and others) and tested but it's still not right. I should probably add that when I run my show, the prop has some odd results...

My xlights setup is working great except for 1 prop - a window prop. I've checked the configuration up and down and can't find the culprit. I'm hoping this community can give me some ideas of what may be going wrong. I'm pretty sure it's a configuration I have wrong in xlights. I'm running...

I figured it out. I had to disable "Use Smart Remote" on the arches because they were not using this feature.

Here's the photos.

I'm almost done with my setup but am having one issue and I thought someone might be able to point me in the right direction. In the attached pictures, you'll see my arches which are new to my display. The first few pixels don't work correctly but the rest of the arch does does. It's hard to...