Recent content by Shane G

I would keep the total load on that wire at a maximum of 8 amp's (5 would be better) as your connectors are the limiting factor in the wiring setup. A bigger cable in between the connectors only helps to get those amp's to get to the other end. A work around would be to solder two or more...

I use Sonoff Wi-Fi smart switches with the eWelink app . I set the timing of the on and off 4/5 years ago and haven't touched them yet , They are much the same as Johnnyboy Shelly's but I place mine at the power outlets.

Depending on how many other ports you are powering off that power supply to your controller and how big it is you might be getting close to maxing out the power supply but as your pic above the 2.2.2 splitter would be the easiest way to go. Me, I only power 50 pixels off a controller port as if...

This is where I get my coro from https://bfsplastics.com.au/ They said their 8mm is stronger than the 10mm as it has more cores in it.

I'm Still good but only have 10 to 14 days now that prior to the event to be available in Sydney a Friday zoom meeting should be good for me.

Under the category of exhibition stand erectors $1150 for 12 months $630 for 6 months $350 for 3 months my insurance is for party hire not sure if it is applicable or not in this case.

I'm sure we can handle it all. I have an ABN but only half the amount of insurance needed I set up fairy lights for weddings for the last 5 years. I think it will be the paper work to be the biggest hurdle.

Was thinking the same but a 360* tunnel meaning you are walking over the lights on a walkway in the middle of the tunnel.

I would love to be part of it Keith. Need more info .

Yes please.

Yes it is, Cement tiles are common for Austraila your average house would have about 15 to 20 ton of tiles this is why most here dont have atics up in the roof space as it is full of trusses at 600mm centers (2 Feet).

as a user of the magnets myself i used double sided tape to some perspex and put heatshrink over it and screwed a conduit clip to that. Just make sure you have the magnets sealed or you will get rust stains on the metal you are sticking them to.

I use Unifi her too only use a mesh Ap if runing a cable is not posible

find your local rc hobby shop and ask for DuoBro 4-40 fastners. Vic Hearns Hobbies SA Modelflight WA Perth RC Local ToyWorld or Mr Toys all of the above will have them

For what it's worth I would just stick to one type of connector makes for expansion and alterations easy in the future.