Answered lytworx Stars

Juddge

Juddge

Full time elf
Generous elf
Joined
Oct 15, 2023
Messages
139
Location
Penrith
i have a set of lytworx stars with 150 lights that runs on 5 v and is 3 wire, and they look like 5v pebbles
the controller outputs 5V and 0.3V from the centre pin, which should be data line
i have hooked them up but they wont work on a normal pixel controller
 
Likely it's a different protocol. Would probably need some signal analysis on the supposed data line to see what they timing etc is like and if it matches one of the other protocols out there
 
From this board would the centre pin be data ?
 

Attachments

  • IMG_5573.jpeg
    IMG_5573.jpeg
    688.9 KB · Views: 19
  • IMG_5572.jpeg
    IMG_5572.jpeg
    616 KB · Views: 18
Juddge said:
From this board would the centre pin be data ?
Click to expand...
Looks like the one with the 0 ohm link is the data line, as it's coming from the daughter-PCB. Follow the track. The other two, if you turn the board over, see the marking for the capacitor (circle with the slightly thicker black line on one side) sits right over the other 2 tracks, indicating power.
 
I put the deer's up on Facebook, the middle on them was data and the controller looked identical
 
Thaks guys , figured it out now, and YAY they are just standard seed string lights 5V sso now i dont have to pul them apart
 
I got the reindeer lytworx from bunnings, it's a bit agricultural but this is how I got them going on a pixel tester. Red +, yellow D and black -20241110_121501.jpg20241118_165112.jpg
 
You must log in or register to reply here.
Back
Top