ACL strobes and wal warts

Discussion in 'Strobes - LED or Others' started by DanoNJ, Aug 7, 2012.

  1. DanoNJ

    DanoNJ Full Time Elf

    Joined:
    May 12, 2010
    Messages:
    170
    Likes Received:
    0
    Location:
    Monroe Twp., NJ
    Quick question - looking for thoughts. I have a 5vdc wal wart that's pushing out about 5.75v without a load. Think I can use this to power the strobes, or too much?
     
  2. fasteddy

    fasteddy I have C.L.A.P Global Moderator Generous Elf

    Joined:
    Apr 26, 2010
    Messages:
    6,471
    Likes Received:
    16
    Location:
    Albion Park NSW
    Find Me On:
    Now the specs for the PIC10F200T-I/OT are: Max supply voltage - 5.5 Volts Min supply voltage - 2 Volts

    the Nud and transitor can easily handle above 6 volt , so its the PIC that will cause you the issues at your proposed voltage.
     
  3. OP
    OP
    DanoNJ

    DanoNJ Full Time Elf

    Joined:
    May 12, 2010
    Messages:
    170
    Likes Received:
    0
    Location:
    Monroe Twp., NJ
    Good to know. Thanks,Eddy
     

Share This Page