Anyone have CTB32LD-G3 or LOR1602 board?????

ShellNZ

Senior elf
Joined
Jun 17, 2012
Messages
892
Location
Karaka, Auckland, NZ
Im just wanting close up pictures of the board itself.

My board unfortunately as it turns out has resistors etc for 110v, not 240v.

Im wanting to see the differences of the 240v ones to see if I can modify it.

Any help would be much appreciated!!!
 

AAH

I love blinky lights :)
Community project designer
Joined
Dec 27, 2010
Messages
4,188
Location
Eaglehawk
There's a woman I know in NZ who has 1. It doesn't go though :p
 

AAH

I love blinky lights :)
Community project designer
Joined
Dec 27, 2010
Messages
4,188
Location
Eaglehawk
Did you ever find a picture of 240V ones Shell as I currently have some here that were sent to me for repair and there doesn't appear to be any info anywhere on what resistors should be on the 240V CTB32LD boards. The 150k that are on them now melt off at 240V.
 

AAH

I love blinky lights :)
Community project designer
Joined
Dec 27, 2010
Messages
4,188
Location
Eaglehawk
Below is a photo of a CTB32LD that is properly configured for 240V (and a 110V one damaged by 240V). There's a whole bunch of variations to the 110V ones.
These include
-power jumper set for 240V
-optocouplers U1, U2 etc (16 of) MOC3052 (110V has MOC3023)
-R75, R76, R78 & R79 30k (110V has 15k)
-R3, R6, R7 etc (16 of) 120k (not sure if 110V has any installed)
-R1, R4 etc (16 of) 2k2 (110V has 330R)
I didn't check the triacs to see if they match
There may be other variations
.Genuine 240V CTB32LD.jpg 110V CTB32LD.jpg
 
Last edited:
Top