The Bald Boy
New elf
HI all,
I have a lot of dumb Big W lights with a MFC. I would like to get rid of the power pack that comes with it and use a PSU. This will save me a lot or power boards and extension cords!!
I am not sure of the following:
AC-DC adaptor
model KMD-240-01000-48SA
input 230-240V-50-60Hz
output 24V=10VA
AC-AC Adaptor
model KMA-220-01000-41SA
nput 230-240V-50-60Hz
output 22V=10VA
AC-AC Adaptor
model KMA-220-00800-41SA
nput 230-240V-50-60Hz
output 22V=8VA
Power supply
model: MKV-C-300-130-AU
PRI: 220-240V-50/60Hz 0.16A
SEC: 30V - 0.43A 13W
Aah has said the MFC is:
It's a 3 wire 2 channel controller assuming that it's both power and lights that are coming in the bottom.
I currently have a Falcon F16v3 and a Raspberry pi 3B+. I will run a 12V PSU to the Falcon for some led strips I have purchased.
Sorry about the long message - just trying to give as much information as possible. I am really new to all of this
I have a lot of dumb Big W lights with a MFC. I would like to get rid of the power pack that comes with it and use a PSU. This will save me a lot or power boards and extension cords!!
I am not sure of the following:
- What type of controller I need, if needed at all?
- Can I just plug the wires from the LED into the PSU?
- Can I use the MFC that comes with it to ensure the light changing pattern? Or Do I need something else?
- What size PSU would I need? I am thinking 30V and winding it down. I have read on this site that although the power pack that comes with the lights might say 24V - they actually run at a higher voltage
AC-DC adaptor
model KMD-240-01000-48SA
input 230-240V-50-60Hz
output 24V=10VA
AC-AC Adaptor
model KMA-220-01000-41SA
nput 230-240V-50-60Hz
output 22V=10VA
AC-AC Adaptor
model KMA-220-00800-41SA
nput 230-240V-50-60Hz
output 22V=8VA
Power supply
model: MKV-C-300-130-AU
PRI: 220-240V-50/60Hz 0.16A
SEC: 30V - 0.43A 13W
Aah has said the MFC is:
It's a 3 wire 2 channel controller assuming that it's both power and lights that are coming in the bottom.
I currently have a Falcon F16v3 and a Raspberry pi 3B+. I will run a 12V PSU to the Falcon for some led strips I have purchased.
Sorry about the long message - just trying to give as much information as possible. I am really new to all of this