ECG-P12S/P12D combo with dead outputs

[moondew]

Has anyone run into an issue with an ECG-P12S/P12D combo board set where there is no data on the second six outputs?

I reflashed the board from 3.4 to 3.4b and now all the outputs are dead. :-(

-Tom

 

[moondew]

I reflashed the P12S board with firmware 3.4b and then all outputs were dead. I reflashed again just incase I made a mistake but still all dead.
Strangely, the ASIC version numbers on the System Information web page were all zeros.

So I flashed 3.4 instead and now all outputs work. I am guessing that ten years ago when I originally flashed 3.4 I must not have programmed the second ASIC. Unfortunately, 3.4 does not support two full universes per output with 2811 pixels.

However, I would really like to get 3.4b working. I sent Ed an email but I will be surprised if he replies.

 

[battle79]

This could hopefully help. Can't remember what I did, but mine is running two universes no problem. This should be everything I used to update my J1Sys controllers.

Microsoft OneDrive

1drv.ms

Regards,
Rowan

 

[moondew]

Unfortunately, you only have LP035 firmware and my board needs LP047

 

[battle79]

Moondew, have another look in my folder, I found some more files that are likely what you need.

Found this link and thought I could get them, but alas it only has the links.

Index of /files/j1sys/ECG-P12S/

That said, maybe ask David if he still has the files somewhere.

 

[moondew]

Those files are not available on web.archive.org

 

[battle79]

But he site they were on was David_AVDs. So messaging him might still yield results if he has the files somewhere.

Good luck mate,

 

[David_AVD]

I just checked and still have some J1SYS files. Are these what you need?
ECG_P12S_v3_4.hex
ASIC_P12S_v3_4B_LP047.ahex

 

[David_AVD]

I've PM'd you with a link to the ECG-P12S folder.