I havesetup ESPPixelSticks on a Dig Octa board. I got softaware flashed, got the memoriy card. But theer are some things I am confused about.
1) As much as the controller section on XLIGHTS connected with the ETh connection, the FPP connect option could not find the contoller. When I changed the IP address on the Controller section to the WiFi Ip address, the FPP Connect found the controller and ws able ot upload the Sequences.
Question: can I use the Dig Quad connected by Ethernet? and if som, what amd I missing?
- The Network settings on the ESPPixelSTick software has both Wifi and Ethernet turned on.
2) My boards have a relay setup to turn on and off the power supply. Running WLED it worked great, but I cannot get the relay to turn on when I start show. I have set output 9 to relay and the GPIO to 33.
I would like the relay to turn on the power supply whe the show starts .
Any suggestions?
1) As much as the controller section on XLIGHTS connected with the ETh connection, the FPP connect option could not find the contoller. When I changed the IP address on the Controller section to the WiFi Ip address, the FPP Connect found the controller and ws able ot upload the Sequences.
Question: can I use the Dig Quad connected by Ethernet? and if som, what amd I missing?
- The Network settings on the ESPPixelSTick software has both Wifi and Ethernet turned on.
2) My boards have a relay setup to turn on and off the power supply. Running WLED it worked great, but I cannot get the relay to turn on when I start show. I have set output 9 to relay and the GPIO to 33.
I would like the relay to turn on the power supply whe the show starts .
Any suggestions?