Hello,
I am trying to get my Picap to light up ws2811 node lights in test mode. The PiCap is connected to Raspberry Pi 3B+ and I have the Falcon FPP installed and running on it.
However, nothing lights up. The voltage is checked at 12.1v per multimeter, so I am pretty sure that the data line is the problem. How can I debug to figure out if its the Falcon PiCap that is not working or the FPP player is not sending anything (perhaps due to my configuration settings).
Here is a screenshot of my configuration as well as my setup
I am trying to get my Picap to light up ws2811 node lights in test mode. The PiCap is connected to Raspberry Pi 3B+ and I have the Falcon FPP installed and running on it.
However, nothing lights up. The voltage is checked at 12.1v per multimeter, so I am pretty sure that the data line is the problem. How can I debug to figure out if its the Falcon PiCap that is not working or the FPP player is not sending anything (perhaps due to my configuration settings).
Here is a screenshot of my configuration as well as my setup