1. New to Christmas lighting? Get started with the AusChristmasLighting 101 Manual:
    auschristmaslighting.com/wiki/AusChristmasLighting-101

From e131 to dmx

Discussion in 'DMX, E1.31 & Networking' started by roo, Jan 11, 2015.

  1. roo

    roo Full Time Elf

    Joined:
    May 9, 2014
    Messages:
    136
    Likes Received:
    0
    Location:
    Lake Haven NSW
    Hi all,


    This is my setup at the moment. I have a E6804 which is running my pixeltree with a 12 volt power supply. I have that connected via output 4 to a 2811dc15 board. Which is running my big w lights with a 27V power supply. I then want to run a 27 channel ray wu dmx board. What do I need in between the 2811dc15 board and the ray wu boards?


    Cheers
    roo
     
  2. AAH

    AAH I love blinky lights :) Community Project Designer

    Joined:
    Dec 27, 2010
    Messages:
    2,625
    Likes Received:
    36
    Location:
    Eaglehawk
    Find Me On:
    The E6804 has no dmx output on it so you would need something like a J1Sys D2 to get from e1.31 to dmx.
     
  3. OP
    OP
    roo

    roo Full Time Elf

    Joined:
    May 9, 2014
    Messages:
    136
    Likes Received:
    0
    Location:
    Lake Haven NSW
    so I could run a cat6 cable from the pc to a switch then run a cat6 to the e6804 which connects to the 2811dc15 and then in another port run cat6 to the d2 which I have and then to the ray wu board?
     
  4. OP
    OP
    roo

    roo Full Time Elf

    Joined:
    May 9, 2014
    Messages:
    136
    Likes Received:
    0
    Location:
    Lake Haven NSW
    and you meant a ECG-D2 Im taking?
     

Share This Page