Interface USB DMX Enttec - LED Strip Controller Fail

Discussion in 'RGB Lights - Intelligent Pixels and 3-Channel RGB' started by Javier V2, Oct 22, 2016.

  1. Javier V2

    Javier V2 New Elf

    Joined:
    Oct 22, 2016
    Messages:
    1
    Likes Received:
    0
    Hello everyone,
    Writing from México, my first post here, looking for a solution. I don't Know if i'm at the right place but i hope so.


    I've got an Enttec pro usb dmx interface with a Chamsysq on pc. To light 60 led stripes with generic 12 ch. LED controllers.
    It looks like easy cake. But when i plus the dmx wire it doesn't work.
    Led stripes respond fine using a WorK 12 ch. Desk.
    Chamsys-enttec system works fine with led fixtures.
    LED controllers receive and transmit the dmx signal to other led fixtures.
    Sometimes the interface and programm got in conflict when plus the dmx controller.
    I already tried to change + for - on dmx wire to led controller.
    It'se very strange to me...
    Maybe not for someone.
    Thanks for tour help.
     

Share This Page