Hi I’m new here. I have 3 strings of Lytworx leds illuminating a tree, each with its own controller connected through a 240v timer. Two of the three do not behave. Instead of staying on the fixed setting I selected, when the timer next turns on they seem to go to one of the flashing options that wasn’t selected. I’ve reset several times but it remains a problem. Does anyone have a solution other than replace the lights? Also does anyone know where I can get a transformer that doesn’t of the different pattern options. It seems to be 240v to 32v ac. Thanks in advance.
Lyteworx transformers
- Thread starter Bobke
- Start date
-
- Tags
- controller setup
hanson electronics
DC2-24 - prebuilt ready to run, can be used as a stand alone controller, anything plugged into this controller, will do the one setting for all outputs
will allow for 12 outputs
www.hansonelectronics.com.au
DC2-24 - prebuilt ready to run, can be used as a stand alone controller, anything plugged into this controller, will do the one setting for all outputs
will allow for 12 outputs
Ready to run DMX2-24 | Hanson Electronics
Ready to run DMX2-24 light dimmer for fairy lights
www.hansonelectronics.com.au
i used this for 2 years to ensure all my standard 2 wire lights all did the same function / program all night every night,
and it will still do it for may years to come, until i finally replace all lights with Pixels
and it will still do it for may years to come, until i finally replace all lights with Pixels
Notenoughlights
400,000+ twinkly lights
I bought a motor driver, essentially an H bridge with fancy controls. Hooked to an esp32 running wled, as it can now drive h bridges, I use it to run about 40 sets of string lights from one single power supply. Really cuts down on the multiboards lol