I am setting up a up a J1Sys P12 in vixen 3. Currently I have added the P12 as one controller (E1.31 type) with 6120 outputs. This makes it a bit tricky when I want to patch an element to say universe 10 (output10).
Is it possible to set up the P12 as 12 separate E1.31 controllers, each with the same IP address, but having different universe numbers. That way I can patch just to the specific output (universe) of the P12.
eg the basic set up would be
P12 Uni1 = Universe 1 1 510 unicast 192.xxx.xxx.10
P12 Uni2 etc
...
P12 Uni12 = universe 12 1 510 unicast 192.xxx.xxx.10
I have tried a search on P12 set up in vixen3 on a few forums without any luck, is there a V3 controller setup guide that any can point me to?
Is it possible to set up the P12 as 12 separate E1.31 controllers, each with the same IP address, but having different universe numbers. That way I can patch just to the specific output (universe) of the P12.
eg the basic set up would be
P12 Uni1 = Universe 1 1 510 unicast 192.xxx.xxx.10
P12 Uni2 etc
...
P12 Uni12 = universe 12 1 510 unicast 192.xxx.xxx.10
I have tried a search on P12 set up in vixen3 on a few forums without any luck, is there a V3 controller setup guide that any can point me to?