Eizziljam
I’m Christmas crazy!
Hi all, firstly thank you to everyone who has patiently answered my newbie questions so far, I’ve planned my set up and now I’m ready to get the equipment to start building etc. I’ve done a course so I understand more about the setup, power requirements, sequencing and stuff. The thing I lack most knowledge in is electrical wiring, and what exactly to order.
I’ve got a few questions:
I’ve got a few questions:
- Do you usually order seperate strings of nodes for each element?
- What is the recommended wire spacing for nodes if im putting it into coro strip (or really what’s the recommended excess wire because obviously it depends how spaced out I want the lights in the strip)
- Same question as above but for ELD coro props... is there a standard spacing that is recommended to order that will work with all of the props?
- I’ve seen people talk about connectors, and I know it’s a personal choice but as a newbie starting fresh what is recommended?
- Can I ask ray wu for say 1m of pixel nodes and then 3m of cable attached to it so I can bring it back to my power/controller source? Or is this something I should do myself?
- Arches - I’ve worked out the measurements of my arches, and want to use strip inside the air seeder hose- is it advisable to order the strip in the lengths I want for each arch rather than cut it myself? So like 6 lots of 3m strip with pigtails at each end to join them together?
thanks in advance for your advice!