1. New to Christmas lighting? Get started with the AusChristmasLighting 101 Manual:
    auschristmaslighting.com/wiki/AusChristmasLighting-101

P2 - Can someone with one of these check something for me?

Discussion in 'EthConGateway by Joshua 1 Systems' started by kane, Sep 10, 2012.

  1. kane

    kane Dedicated Elf

    Joined:
    Dec 23, 2010
    Messages:
    1,021
    Likes Received:
    0
    Location:
    Trigg (Northern suburbs of Perth)
    Find Me On:
    Hey All

    Setup the P2 over the weekend, and found a potential small glitch which Ed hasn't seen before, so I just thought I'd see if someone else can reproduce.

    It seems that the effect configuration doesn't seem to save after a reboot - so if anyone has a P2 handy that's connected, can you maybe test this out?

    (as it turns out, it's not an issue for me as I've just set the RGB orders in LSP, but if it is an issue, I'm sure it'll cause grief for someone else at some point)

    Thanks

    Kane
     
  2. ShellNZ

    ShellNZ Senior Elf

    Joined:
    Jun 17, 2012
    Messages:
    848
    Likes Received:
    1
    Location:
    Karaka, Auckland, NZ
    Find Me On:
    If I recall, havent got P2 hooked up at the moment....

    If the effect can NOT exist, error in config, then it wont save, it reverts back to 0.

    I might be wrong :)
     

Share This Page