1. New to Christmas lighting? Get started with the AusChristmasLighting 101 Manual:
    auschristmaslighting.com/wiki/AusChristmasLighting-101

P2 Strobe Control in Multicast

Discussion in 'EthConGateway by Joshua 1 Systems' started by Ɠαяєтн, Jun 30, 2014.

  1. Ɠαяєтн

    Ɠαяєтн Mae gen i C.L.A.P ei heintus iawn

    Joined:
    Dec 27, 2010
    Messages:
    160
    Likes Received:
    0
    Location:
    Landsdale, Perth, Western Australia
    I have just been trying to control the strobe effect of a P2 using LOR S3.


    What I have found is that the control universe will not work when LOR universe is configured in multicast (ok in unicast). The reason I believe is that the multicast filter is not configured as shown on the system info page of the P2.


    If you configure a spare output on the P2 with the same universe as the strobe control universe then the multicast filter is created, and the strobes work when controlled in multicast.


    One other thing I found, the string universe and control universe can not be the same, even if they are using different channels.
     

    Attached Files:

  2. OP
    OP
    Ɠαяєтн

    Ɠαяєтн Mae gen i C.L.A.P ei heintus iawn

    Joined:
    Dec 27, 2010
    Messages:
    160
    Likes Received:
    0
    Location:
    Landsdale, Perth, Western Australia
    I have just received an email from Ed at J1sys. It appears that the control universe isn't getting added to multicast. He is going to look at the code.
     
  3. Benschristmaslights

    Benschristmaslights Dedicated Elf Global Moderator Generous Elf

    Joined:
    May 2, 2010
    Messages:
    2,125
    Likes Received:
    7
    Location:
    Elderslie
    Find Me On:
    lets hope he can add it this season
     

Share This Page