pixels glowing red

[Dennisl]

Hi everyone new problem ,I'm running 2 universe of 110 pixels on each universe of a ECG-p2 powered by 350 watt power supply injecting power every 50 pixels plus at end of the line ,everything works fine when running a sequence the problem I have after about an hour or more not running a sequence the pixels come on a very faint red glow if I unplug power supply they shut off but when I plug power supply back in they will glow again in about an hour this is first year using this setup . Anyone have any ideas on how to correct this problem. Thanks Dennis

 

[Robert]

Check to see the voltage from the PS is at 12v. There was just a post about the same problem. I believe turning the voltage down, from 12.5v to 12v fixed the same issue.

 

[Dennisl]

Thanks or the tip my voltage was at 12.7 volts adjusted to 12 volts problem fixed thanks Dennis

 

[Robert]

Glad you got I fixed