pixels glowing red

Dennisl

New elf
Joined
Mar 20, 2011
Messages
39
Location
Burbank il
Hi everyone new problem ,I'm running 2 universe of 110 pixels on each universe of a ECG-p2 powered by 350 watt power supply injecting power every 50 pixels plus at end of the line ,everything works fine when running a sequence the problem I have after about an hour or more not running a sequence the pixels come on a very faint red glow if I unplug power supply they shut off but when I plug power supply back in they will glow again in about an hour this is first year using this setup . Anyone have any ideas on how to correct this problem. Thanks Dennis
 

Robert

Apprentice elf
Joined
Dec 5, 2012
Messages
92
Location
Wisconsin
Check to see the voltage from the PS is at 12v. There was just a post about the same problem. I believe turning the voltage down, from 12.5v to 12v fixed the same issue.
 

Dennisl

New elf
Joined
Mar 20, 2011
Messages
39
Location
Burbank il
Thanks or the tip my voltage was at 12.7 volts adjusted to 12 volts problem fixed thanks Dennis
 
Top