1. New to Christmas lighting? Get started with the AusChristmasLighting 101 Manual:
    auschristmaslighting.com/wiki/AusChristmasLighting-101

Purchase item

Discussion in 'Hanson Electronics' started by sparkulator, Dec 11, 2015.

  1. sparkulator

    sparkulator New Elf

    Joined:
    Nov 30, 2015
    Messages:
    5
    Likes Received:
    0
    Location:
    FNQ
    Hi Al

    Would like to purchase
    1 x DMX36
    1 x USB to DMX dongle
    Will be used with Vixen.

    Are they still in stock.
    Will order through web site if all ok.

    Cheers.

    Andy.
     
  2. AAH

    AAH I love blinky lights :) Community Project Designer

    Joined:
    Dec 27, 2010
    Messages:
    2,544
    Likes Received:
    14
    Location:
    Eaglehawk
    Find Me On:
    DMX36 went out of stock overnight so I finished off 2 more this morning instead of putting up lights :(
    There's 2 DMX36 in stock at the moment and a fair few dongles.
     
  3. OP
    OP
    sparkulator

    sparkulator New Elf

    Joined:
    Nov 30, 2015
    Messages:
    5
    Likes Received:
    0
    Location:
    FNQ
    Do these USB DMX dongles work with Vixen 3 ???
     
  4. AAH

    AAH I love blinky lights :) Community Project Designer

    Joined:
    Dec 27, 2010
    Messages:
    2,544
    Likes Received:
    14
    Location:
    Eaglehawk
    Find Me On:
    They work as an "open dmx" dongle under Vixen, Light-O-Rama, Xlights, LightShowPro and probably HLS. They also work with da_dmx, lights_up and other testing software and plug into a PI running FPP.
     
  5. madmaxisback

    madmaxisback New Elf

    Joined:
    Nov 6, 2015
    Messages:
    25
    Likes Received:
    0
    Location:
    Malaga
    I have these dongles and 2X DMX36 and Vixen, Pi running FPP and they work GREAT! Really nice quality boards and the DMX dongle just works.
     
  6. OP
    OP
    sparkulator

    sparkulator New Elf

    Joined:
    Nov 30, 2015
    Messages:
    5
    Likes Received:
    0
    Location:
    FNQ
  7. lizardking

    lizardking IT IS STILL ALL BENS FAULT

    Joined:
    Dec 26, 2014
    Messages:
    416
    Likes Received:
    0
    Location:
    Gold Coast
    Find Me On:
    AAH is there a way or using any of your boards just to turn a whole net light on and off if it only has 2 wires my thought was to use the 3 wires for the channels and use a 5 pin relay just to open and close the circuit would this work for a 2 wire situation
     

Share This Page