Hi there. In short I'm 3 days in and still cant figure where i have gone wrong. I am trying to have my PI 4 wifi from my computer and ethernet to my Beagle Bone Black controller (with hanson 123 48 output controller). I have followed the steps i believe required but in x lights i can upload data to my PI playlist on xlights using fpp connect but not fpp connect xlights to the beagle bone. If i ethernet to the beagle i can put the playlist in there and it will play from the pi schedule or if i manually hit play in the pi ip address.
I have setup my network as follows: my home router gateway is 192.168.1.1 I have set a static route in my router as network host 192.168.200.0 mask 255.255.0.0 and gateway 192.168.1.68. For just static address the pi and beagle in Asus router (PI 192.168.200.1) and Beagle (192.168.200.2) and left gateway as default. i have command prompt as administrator -p add 192.168.200.0 mask 255.255.0.0 192.168.1.68
I have put in the Pi itself ETh0 IP 192.168.200.1 mask 255.255.0.0 and left the gateway empty, Wlan0 I have IP 192.168.1.68 mask 255.255.0.0 and gateway 192.168.1.1 . The Beagle Bone Black.
I have no idea where I have gone wrong from the Falcon instructions ( using v6.2) I have enabled port forwarding but am also unsure of exactly how i should have the controllers configured in x lights and if perhaps that is where my issue lies.
Just to recap - I can play my playlist remotely from my computer and put new songs on the PI. Cannot play new songs that I have put on however unless i plug an ethernet lead into the beagle and upload same song. I have no local access to the beagle so cant see anything in there unless i ethernet to it. I can access the Pi no problem via the 192.168.200.1 IP.
Any help would be greatly appreciated
I have setup my network as follows: my home router gateway is 192.168.1.1 I have set a static route in my router as network host 192.168.200.0 mask 255.255.0.0 and gateway 192.168.1.68. For just static address the pi and beagle in Asus router (PI 192.168.200.1) and Beagle (192.168.200.2) and left gateway as default. i have command prompt as administrator -p add 192.168.200.0 mask 255.255.0.0 192.168.1.68
I have put in the Pi itself ETh0 IP 192.168.200.1 mask 255.255.0.0 and left the gateway empty, Wlan0 I have IP 192.168.1.68 mask 255.255.0.0 and gateway 192.168.1.1 . The Beagle Bone Black.
I have no idea where I have gone wrong from the Falcon instructions ( using v6.2) I have enabled port forwarding but am also unsure of exactly how i should have the controllers configured in x lights and if perhaps that is where my issue lies.
Just to recap - I can play my playlist remotely from my computer and put new songs on the PI. Cannot play new songs that I have put on however unless i plug an ethernet lead into the beagle and upload same song. I have no local access to the beagle so cant see anything in there unless i ethernet to it. I can access the Pi no problem via the 192.168.200.1 IP.
Any help would be greatly appreciated