Recent content by ausnz

Zoom room is just outstanding! Bunch of legends. The issue was the controllers sending information back to themselves causing all the issues.

Thank you

Zoom room? Yes that obviously makes sense now, wasn’t aware it would be such an issue to set it back up.

Can do remote login if it is helpful have looked at the error log files but its like interpreting hieroglyphics.

I deleted my xlights files folders, controllers everything (i was trying to tidy up my files) Now im two days in and no idea what ive done. I have re inputed my props all manually again, and what i think is the correct ontroller settings , then have redone my sequences because of the issues...

Thanks Skymaster, I can give that a crack. If i then fpp the change to the controller, do you think that will change where the display shows on the tree.

Hi Cranzy. Thanks for the response. The blue line is to the front but slightly to the right (not sure how to change that, but the main display is of images etc seem to start at the rear of the tree like it literally needs to spin 180 degrees.

Hi there, wondering if anyone knows a solution rather than physically spinning the mega tree. Wanted to have the main images etc on the front of the 360 degree tree but it seems the majority of the sequenced display the back. Xlights have some settings but not sure if they are for that or not...

Thanks Tooms, i’ll change that all out and see how it reacts, i see what your saying there.

Hi there. In short I'm 3 days in and still cant figure where i have gone wrong. I am trying to have my PI 4 wifi from my computer and ethernet to my Beagle Bone Black controller (with hanson 123 48 output controller). I have followed the steps i believe required but in x lights i can upload...