Recent content by BundyRoy

G'day Logan. I was wondering, would it be better if the pixels were all facing uphill to prevent water ingress in the end with the power. So when you get to the peak switch the pixel through 180 degrees and then work your way down. You could still get the same spacing I think due to the cord...

Thanks David. All lights do have a common ground but it is linked at the lights not the controller/psu. I know this is not as good but hopefully it is good enough. I just moved the controller and the problem disappeared. Apparently it is not the best to leave your controller sitting on a bunch...

Forgot to mention when i was using da e131 the lights flickered the same on blue/red/green as on white.

Fantastic job. Must give you a feeling of satisfaction seeing them in action looking so good.

Have set up all my lights on the ecg p12x and they all work but the matrix (10 x 90 pixels ink1003) seems to flicker. When i put it on full white in da e131 it is very bright but almost like a strobe. Everything else works fine. I've tried changing the speed settings in the controller. Doesn't...

I have a ecg p12X and the when i first tried to send data to the unit it would not work even though I was using the right universe in da e131. I changed the universe settings in the controller to something else then resaved them back to what they were originally and all of a sudden it all worked...

Alan, one of the V+ terminals doesn't seem to be getting any voltage. Is this something I can fix. I haven't had a good chance to double check that it wasn't just a bad connection but when I moved the wires to one of the other v+ terminals they worked. So no panic, as it all works but it is...

Excellent. Thanks David.

Due to controller issues and not having another controller that does dmx output I have to run my 1 lor controller through the dongle they give you with the software. I assume I just change the universe that goes to the LOR controller to the lor adapter with raw dmx. Then run a network cable from...

Thanks Alan. I only connected gnd and data from the pixel input at first and nothing happened. Connected +ve as well and all good so I hoped this was right. Thanks for the confirmation.

I'm a little nervous with power connections at the moment after shorting out and damaging the CPU on my pixlite 16. Alan on the 2811dc30 I am using a separate power supply on the 2811dc30 to run the lights to that used by the controller sending the signal to the 2811dc30. Do I have to disconnect...

Looks like a damaged the CPU due to a short over the data line. It's off to advatek today for repairs.

I did fix it Boof63 but then had to pull that contoller off the matrix as I blew up my pixlite controller. I've got give up on the new matrix this year and use the controller to run the rest of my show.

I've been working through tests with Luke. It's not looking good. I've tried to force bootloader and that doesn't work. Will see what Luke says tomorrow but I think it may be all over before it even began.

My pixlite 16 has stopped working. When I power it up the status and power lights flash very briefly then nothing. There is 12.4v at both sides of the board so it's not the power supply. I checked the logic fuse and its not broken. Still no resistance through fuse (500mA logic fuse) so fuse...