Power supply issues, we think a surge in the network one day fried something in the plug pack and a couple of chips on the board. Had one of my electronic friends go over it and managed to repair so we are all good again for this year.
Yup I understand all of that. I use Ruckus APs with beamforming and all the smart channel features. It could also be done to the fact that I had the cheapest ESP8266 from Aliexpress and I doubt the quality control was up to much. 6 of the 8 were rock solid the other two were a bit iffy and...
Last year my Falcon failed halfway through my show. I ended up flashing 8 x ESP 8266s that evening and had the show running again the next day. Wifi was ok but not great at some of the furthest points in the garden. I think enclosures have a big part to play as well as where you located the APs.
I purchased an LRS-350-5 a few weeks ago from element14 (NZ site, NZ address on invoice so I think insurance will be fine) cost $79 plus GST. Arrived from Aus stock in just over a week.
I am keen on buying some regardless. Have just been asking about shipping to the South Island. Happy to grab a few extra if you want some and can drop off next time I am passing CHCH.
I am currently trying to hunt down some tubing for arches / rope light path sort of thing. Have purchased from Pex-B from bunnings (special order hell ) 12 week delay and also some tubing from NZ safety backwoods. I need to test it now I am bringing the display down. Hopefully get some decent...
Being in NZ and delivery prices being high I am looking at alternatives to Chromamesh. Bunnings has 12x12 mesh that I am thinking of using. Here is an old panel with a pixel its a snug fit. I am going to pop along and test the PVC coated one sometime this week Bunnings NZ Mesh
Thanks for the reply guys, gave up in the end and replaced the F48 with 7 ESP 8266 boards I had around for other projects. Ended up just using WLED and syncing the controllers across my Wifi network. Worked OK had some sync issues but nothing that anyone viewing would notice. Not had much luck...
Came home tonight and found my F48 was not on been working fine since December 1st
Checked the 5V supply with the multimeter and got a steady 5v.
What can I check on the board in order to narrow down the issue?
Any common failure points to look for?
I have the same HP supplies they are very common from the DL380 / ML380 range of servers.
The pinouts are close but not exactly the same. I think they are 1 pin off from your board design for the 12v / Ground
HP - DPS 800 GB
12v pins 1-12, 53-64
Ground pins 13-24, 39-52
pson/pskill 31-24 - you...
Hey Daryl,
Can I please order the following:
1 x Falcon F48 Pixel Controller
5 x Falcon F16v2/F16v3 Falcon 4-String Differential SmartReceiver Board
Shipping to NZ
Thanks,
Chris