It's ok I figured it out! I didn't set the gateway value correctly for my show network on my master FPP. It pointed to an empty address in the show network rather than my router outside of the show network.
Thank You, I have got this partially working. However, the Raspberry Pi on the show network still cannot access the internet. Is there something else that I may have missed?
Hi all, I want to upgrade the FPP version of my Raspberry Pi. The pi is connected to a separate show network that I can access through my master FPP instance. I have allowed interface routing so that I can access the pi on the show network. I can't currently update FPP because it does not have a...
Hi all,
I have just set up FPP on my Kulp beagle bone controller. I am using it as my main controller and have a second raspberry pi (remote) to control a projector in the show. The setting to "interface across networks" is not showing in the Network Settings of FPP.
I had the option...
I had the other Raspberry Pi to allow me to connect to the show network from my home network. I have not added Wifi to my Kulp because it will be far from my home router with a very weak signal (and will be inside a box). Can the Kulp be run as a Master with the original Raspberry Pi acting as...
Hi all,
Is it possible to pass the audio from the Master FPP to a Slave FPP?
My FM transmitter is part of a Kulp 32 port board which is running in slave mode.
Hi all,
I am beginning to plan out a large led matrix on my garage front door. However, I still would like car access. So the door has to be able to be lifted up and so must the lights.
The garage door is old and is a single panel that lifts up. So it sticks out on an angle when moving into...
Thank you for your suggestions. I was able to find a fix!
I originally had all of the pixels powered through a power box with the Kulp controller on its own power supply (separate to the power box). I then connected a ground wire between the Kulp PSU and the power box to create a common ground...
I have an update.
I am no longer trying to send the data over a UTP cable. I have scrapped the idea of using Esps and I have purchased a Kulp 32A-B. I have replaced 2 runs of the cheap retic wire from the controller to the first pixel with an 18AWG hookup wire.
The wire run from the controller...
Hi all, I just received my Kulp controller and have used my own SD card (32GB) to run FPP on the controller. However, there is no option to grow the file system.
When I boot and re-boot the device it still comes up with the need to grow the file system. But when I click the link this is all I...