Recent content by Ed Slonka Jr

Thanks for the link! Ed

Nice job!!! What type of pixels are you using on the tree? Thanks, Ed

Nato nice test board but how do you keep from getting them mixed up?

Robert, See if this will help or answer your question. Ed http://forums.lightorama.com/index.php?/topic/24613-pixel-question/

Thanks Guys appreciate it. Great advice Bill. :)

Ok, just want to make sure I have the wiring correct. So I don't screw them up. Looking at the picture this is what I see. Black - 12v+ Clock - red Data - green Gnd(12v -) blue Thanks for the help! Ed

Ben, Nice display! Any how to's on the spiral trees and Mege tree? I have the spirals in incandescents and want to change to RGB. What did you use? Any info. would be great. Thanks, Ed

Thanks Eddy, this is my version for this year with a tight budget. It will have 4 strips which is 2 full strips cut in half. Hope to have the funds to do a 12 full strip next year. Definitely will be a great focal piece. Can't wait to see your videos! Ed

Great info. guys! I really appreciate the replies! Thanks, Ed :D

Thanks Brian!

Hi Everyone, I have seen mentioned in several posts about grouping pixels to cut down on channels needing sequenced. How is this done? Software, hardware or both in combination? Thanks for any info. :) Ed

Thanks Ron! ;D

Ron, Thanks for sharing. Where did u find those hubs? Thanks, Ed

Eddy, I posted a little video of what I did with Superstar and S3. https://vimeo.com/43419262 I am running this controller: http://tinyurl.com/89h2cyt and this strip cut to make two: http://tinyurl.com/6mqea7p with a lynx dongle. Can't wait ti get some 2811's and a E1.31 controller. Ed

Thanks Eddy, With the 2811's and the controller should be pretty reasonable to build one vs. an all CCR tree. Ed