Recent content by hwick

Hi, if I already have a F16V3 Pixel Controller and expansion boards for the pixels I have started to run, just wondering as I also have a lot of LED lights/displays if I purchased the DMX2-24 to run the LED’s back through can I use the F16V3 to run the DMX2-24 back to and x lights to control it...

Thanks again, and your right didn't think about future use :)

Many thanks for that, very helpful. Just wondering if you have any suggestions on my last question above about which power supply I can use for just my falcon controller.. thanks

Also for the power supply for the Receiver was trying to keep this simple as possible, is there something else I can use to supply the Reciever with Power instead of a Meanwell larger supply with multiple outputs, I still need 12v as all my Pixels are 12V but is there something smaller or with...

Thanks for your reply, still a bit confused though, if I only have one SmartReciever connected to the Main Controller, does that mean I set the RS rotary dial to '0' and Termination 'ON' for 'Native/Normal' mode. Or as it is a V3 it connects to, do I set the dial to 1 with Termination still on...

Hi all, am new to this 'game', have bought a SmartReciever V2.01 to hopefully connect to my Falcon Controller F16V3 (which also has an expansion card connected), can't find too much on the dip switches for this type, if I was to only run one SmartReciever off the DMX1 on the Main Board, on the...

Just wondering where you recommend buying the pixels and mounting strips from thanks

Thanks good to know

Hi All new to this ...